thumbnail
thumbnail

MAS-D16*## – Standard model (ultra thin)

  • (※)Please add -03 to the end of the model number when ordering cables 200mm long.

Motor specifications

Item Unit Model
MAS-D16H06
MAS-D16R06
MAS-D16H10
MAS-D16R10
MAS-D16H20
MAS-D16R20
Stroke mm 6 10 20
Rated thrust kgf 2 2 2
Resolution μm 0.25 0.25 0.25
Maximum speed mm/s 4 4 4
Screw lead mm 0.4 0.4 0.4
Unidirectional repeatable precision μm 3 3 3
Bidirectional repeatable precision μm 5 5 8
Bidirectional positioning precision μm 10 10 16
Average inversion error μm 3 3 5
Limit sensor Hall sensor
Length (L) mm 68 72 82
Weight g 150 155 160
Product diameter mm φ 16 φ 16 φ 16
  • (Note 1)Use the included nuts when installing onto device. Restricting the body during attachment may lead to decreases in precision.
  • (Note 2)Actuators bear the loads of both the direction in which it thrusts and the direction in which it pulls. Please make sure to add precompression load to one of these directions before use, using equipment such as springs. Backlash will occur if precompression load is not in place, leading to decrease in precision. During pre-shipping inspections, we placed 800gf of compression load on the thrust direction when performing precision measurement. Finally, please make sure the load placed on the pull direction during assembly does not exceed the rated thrust.
  • (Note 3)Actuator cables are not flex-resistant. Please contact us if you plan to use them in situations where repetitive flex stress is to be applied to the product.
Page Top