MAS-D23*## – Standard model

thumbnail
thumbnail

MAS-D23*## – Standard model

  • (※)Please add -03 to the end of the model number when ordering cables 200mm long.

Motor Specifications

Item Unit Model
MAS-D23H10
MAS-D23R10
MAS-D23H15
MAS-D23R15
MAS-D23H25
MAS-D23R25
Stroke mm 10 15 25
Rated thrust kgf 6 6 6
Resolution μm 0.25 0.25 0.25
Maximum speed mm/s 5 5 5
Screw lead mm 0.5 0.5 0.5
Unidirectional repeatable precision μm 3 3 3
Bidirectional repeatable precision μm 5 8 8
Bidirectional positioning precision μm 10 13 20
Average inversion error μm 3 4 5
Limit sensor Hall sensor
Length (L) mm 72 77 87
Weight g 265 270 280
Product diameter mm φ 23 φ 23 φ 23
  • (Note*1)Use the included nuts when installing onto device. Restricting the body during attachment may lead to decreases in precision.
  • (Note*2)Actuators bear the loads of both the direction in which it thrusts and the direction in which it pulls. Please make sure to add precompression load to one of these directions before use, using equipment such as springs. Backlash will occur if precompression load is not in place, leading to decrease in precision. During pre-shipping inspections, we placed 800gf of compression load on the thrust direction when performing precision measurement. Finally, please make sure the load placed on the pull direction during assembly does not exceed the rated thrust.
  • (Note 3)Actuator cables are not flex-resistant. Please contact us if you plan to use them in situations where repetitive flex stress is to be applied to the product.
Page Top