MASC-D16*## – 无尘/无污染气体方案 – 适用于无尘房间/无尘设备

thumbnail
thumbnail

MASC-D16*## – 无尘/无污染气体方案 – 适用于无尘房间/无尘设备

  • (※)Please add -03 to the end of the model number when ordering cables 200mm long.

马达特性

项目 单位 机种
MASC-D16H06
MASC-D16R06
MASC-D16H10
MASC-D16R10
MASC-D16H20
MASC-D16R20
行程 mm 6 10 20
定额推力 kgf 1.5 1.5 1.5
分辨度 μm 0.25 0.25 0.25
最高速度 mm/s 4 4 4
主轴螺纹间隔 mm 0.4 0.4 0.4
一方向重复精度 μm 3 3 3
往返重复精度 μm 5 5 8
往返定位精度 μm 10 10 16
平均逆转误差 μm 3 3 5
限度感应器 霍尔传感器
尺寸 (L) mm 68 72 82
重量 g 150 155 160
外径 mm φ 16 φ 16 φ 16
  • (Note*1)When the motor is revolving in the CW direction, it will move in the direction of the arrow indicated.
  • (Note*2)Always make sure you use the limit switch. Otherwise, the rod may get stuck and become unrecoverable.
  • (Note 3)The logic used by the limit switch is “normally closed.” Please make sure that the limit switch halts pulse output when switched on while connected to an upper level controller.
  • (Note 4)Actuators bear the loads of both the direction in which it thrusts and the direction in which it pulls. Please make sure to add precompression load to one of these directions before use, using equipment such as springs. Backlash will occur if precompression load is not in place, leading to decrease in precision. During pre-shipping inspections, we placed 800gf of compression load on the thrust direction when performing precision measurement. Finally, please make sure the load placed on the pull direction during assembly does not exceed the rated thrust.
  • (Note 5)Actuator cables are not flex-resistant. Please contact us if you plan to use them in situations where repetitive flex stress is to be applied to the product.
Page Top