MASC-D23*## – 无尘/无污染气体方案 – 适用于无尘房间/无尘设备
MASC-D23*## – 无尘/无污染气体方案 – 适用于无尘房间/无尘设备
- （※）Please add -03 to the end of the model number when ordering cables 200mm long.
马达特性
| 项目 | 单位 | 机种 | ||
|---|---|---|---|---|
| MASC-D23H10 MASC-D23R10 |
MASC-D23H15 MASC-D23R15 |
MASC-D23H25 MASC-D23R25 |
||
| 行程 | mm | 10 | 15 | 25 |
| 定额推力 | kgf | 3 | 3 | 3 |
| 分辨度 | μm | 0.25 | 0.25 | 0.25 |
| 最高速度 | mm/s | 5 | 5 | 5 |
| 主轴螺纹间隔 | mm | 0.5 | 0.5 | 0.5 |
| 一方向重复精度 | μm | 3 | 3 | 3 |
| 往返重复精度 | μm | 5 | 8 | 8 |
| 往返定位精度 | μm | 10 | 13 | 20 |
| 平均逆转误差 | μm | 3 | 4 | 5 |
| 限度感应器 | – | 霍尔传感器 | ||
| 尺寸 (L) | mm | 72 | 77 | 87 |
| 重量 | g | 265 | 270 | 280 |
| 外径 | mm | φ 23 | φ 23 | φ 23 |
- (Note*1)When the motor is revolving in the CW direction, it will move in the direction of the arrow indicated.
- (Note*2)Always make sure you use the limit switch. Otherwise, the rod may get stuck and become unrecoverable.
- (Note 3)The logic used by the limit switch is “normally closed.” Please make sure that the limit switch halts pulse output when switched on while connected to an upper level controller.
- (Note 4)Actuators bear the loads of both the direction in which it thrusts and the direction in which it pulls. Please make sure to add precompression load to one of these directions before use, using equipment such as springs. Backlash will occur if precompression load is not in place, leading to decrease in precision. During pre-shipping inspections, we placed 800gf of compression load on the thrust direction when performing precision measurement.
- (Note 5)Actuator cables are not flex-resistant. Please contact us if you plan to use them in situations where repetitive flex stress is to be applied to the product.
