MAB-D28*## – high speed and long service life model


MAB-D28*## – high speed and long service life model

  • (※)Please add -03 to the end of the model number when ordering cables 200mm long.

Motor Specifications

Item Unit Model
Stroke mm 10 30
Rated thrust kgf 5 5
Maximum short-term thrust kgf 10 10
Resolution μm 0.5 0.5
Maximum speed mm/s 50 50
Screw lead mm 1 1
Unidirectional repeatable precision μm 3 3
Bidirectional repeatable precision μm 5 8
Bidirectional positioning precision μm 10 20
Average inversion error μm 3 5
Limit sensor Hall sensor
Length (L) mm 95 115
Weight g 430 480
Product diameter mm φ 28 φ 28

(Note*1)Use the included nuts when installing onto device. Restricting the body during attachment may lead to decreases in precision.

(Note*2)Actuators bear the loads of both the direction in which it thrusts and the direction in which it pulls. Please make sure to add precompression load to one of these directions before use, using equipment such as springs. Backlash will occur if precompression load is not in place, leading to decrease in precision. During pre-shipping inspections, we placed 800gf of compression load on the thrust direction when performing precision measurement.

(Note 3)Actuator cables are not flex-resistant. Please contact us if you plan to use them in situations where repetitive flex stress is to be applied to the product.

(Note 4)The positioning of the M3 attachment screw holes and cables can be arbitrarily determined.

Page Top