thumbnail
thumbnail

MASC-D16*## – Dustproof / clean room model

  • (※)Please add -03 to the end of the model number when ordering cables 200mm long.

Motor specifications

Item Unit Model
MASC-D16H06
MASC-D16R06
MASC-D16H10
MASC-D16R10
MASC-D16H20
MASC-D16R20
Stroke mm 6 10 20
Rated thrust kgf 1.5 1.5 1.5
Resolution μm 0.25 0.25 0.25
Maximum speed mm/s 4 4 4
Screw lead mm 0.4 0.4 0.4
Unidirectional repeatable precision μm 3 3 3
Bidirectional repeatable precision μm 5 5 8
Bidirectional positioning precision μm 10 10 16
Average inversion error μm 3 3 5
Limit sensor Hall sensor
Length (L) mm 68 72 82
Weight g 150 155 160
Product diameter mm φ 16 φ 16 φ 16
  • (Note 1)When the motor is revolving in the CW direction, it will move in the direction of the arrow indicated.
  • (Note 2)Always make sure you use the limit switch. Otherwise, the rod may get stuck and become unrecoverable.
  • (Note 3)The logic used by the limit switch is “normally closed.” Please make sure that the limit switch halts pulse output when switched on while connected to an upper level controller.
  • (Note 4)Actuators bear the loads of both the direction in which it thrusts and the direction in which it pulls. Please make sure to add precompression load to one of these directions before use, using equipment such as springs. Backlash will occur if precompression load is not in place, leading to decrease in precision. During pre-shipping inspections, we placed 800gf of compression load on the thrust direction when performing precision measurement. Finally, please make sure the load placed on the pull direction during assembly does not exceed the rated thrust.
  • (Note 5)Actuator cables are not flex-resistant. Please contact us if you plan to use them in situations where repetitive flex stress is to be applied to the product.
Page Top